| |
| techtalk:ref:tools146 [2018/07/27 01:52] – created hippysmack | techtalk:ref:tools146 [2024/01/24 21:49] (current) – hippysmack |
|---|
| ====== General Engine Electrical, Sensors, etc. ====== | ====== General Engine Electrical, Sensors, etc. ====== |
| ===== O2 Sensor ===== | ===== O2 Sensor ===== |
| An open end 7/8" wrench or crescent wrench will be sufficient to remove / install the O2 sensor. ((Charles: of the XLFORUM http://xlforum.net/forums/showthread.php?t=853778&page=2)) \\ | An open end 7/8" wrench or crescent wrench will be sufficient to remove / install the O2 sensor. ((Charles: of the XLFORUM https://www.xlforum.net/forum/sportster-motorcycle-forum/sportster-motorcycle-intake-and-exhaust/sportster-motorcycle-air-intake-carburetor-efi-fuel-and-exhaust/99610-02-sensor-removal-tool/page2?t=853778&page=2)) \\ |
| However, the tools below will make it a little easier. | However, the tools below will make it a little easier. |
| |
| |
| |{{:techtalk:ref:tools:o2_sensor_tool_by_biknut.jpg?direct&300|}}|{{:techtalk:ref:tools:o2_sensor_socket_1_by_rocketmangb.jpg?direct&300|}}|{{:techtalk:ref:tools:o2_sensor_socket_2_by_rocketmangb.jpg?direct&300|}}| | |{{:techtalk:ref:tools:o2_sensor_tool_by_biknut.jpg?direct&300|}}|{{:techtalk:ref:tools:o2_sensor_socket_1_by_rocketmangb.jpg?direct&300|}}|{{:techtalk:ref:tools:o2_sensor_socket_2_by_rocketmangb.jpg?direct&300|}}| |
| | Box end 7/8" with a section cut out to clear the wire. ((photo by biknut of the XLFORUM http://xlforum.net/forums/showthread.php?t=853778))| 7/8" deep well 6 point socket with a side milled out to clear the wire ((photo by rocketmangb of the XLFORUM http://xlforum.net/forums/showthread.php?t=853778)) || | | Box end 7/8" with a section cut out to clear the wire. ((photo by biknut of the XLFORUM https://www.xlforum.net/forum/sportster-motorcycle-forum/sportster-motorcycle-intake-and-exhaust/sportster-motorcycle-air-intake-carburetor-efi-fuel-and-exhaust/99610-02-sensor-removal-tool?t=853778))| 7/8" deep well 6 point socket with a side milled out to clear the wire ((photo by rocketmangb of the XLFORUM https://www.xlforum.net/forum/sportster-motorcycle-forum/sportster-motorcycle-intake-and-exhaust/sportster-motorcycle-air-intake-carburetor-efi-fuel-and-exhaust/99610-02-sensor-removal-tool?t=853778)) || |
| |
| \\ | \\ |
