Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| techtalk:ref:engmech05g [2019/07/17 05:30] – [REF: Oiling & Lubrication - Sub-05G] hippysmack | techtalk:ref:engmech05g [2023/12/21 21:30] (current) – hippysmack | ||
|---|---|---|---|
| Line 2: | Line 2: | ||
| ====== REF: Engine Mechanicals - Sub-05G ====== | ====== REF: Engine Mechanicals - Sub-05G ====== | ||
| ====== 86-90 Engine Breather Mod Using #4 Cam as an Oil Slinger ====== | ====== 86-90 Engine Breather Mod Using #4 Cam as an Oil Slinger ====== | ||
| - | Article by norseXL of the XLFORUM ((http:// | + | Article by norseXL of the XLFORUM ((https://www.xlforum.net/ |
| This is an idea based from the breathing on the BMW Rotax twins. \\ | This is an idea based from the breathing on the BMW Rotax twins. \\ | ||
| Line 20: | Line 20: | ||
| In drilling the hole in the cam: \\ | In drilling the hole in the cam: \\ | ||
| - | The chances of either carbide or HSS drills working well are not high. ((Ireeman of the XLFORUM | + | The chances of either carbide or HSS drills working well are not high. ((Ireeman of the XLFORUM |
| They tend to walk over the required distance. A gun drill is good or EDM is best for this process. \\ | They tend to walk over the required distance. A gun drill is good or EDM is best for this process. \\ | ||
| You do not want to change to properties of the case hardening (which conventional even with coolant, drilling would do). \\ | You do not want to change to properties of the case hardening (which conventional even with coolant, drilling would do). \\ | ||
